OIML G18 Controlled Vocabulary Julia Neumann 2022-12-16 2023-01-02 10:32:57 en-EN significant fault #00806 For filling instruments where the fill may be greater than one load, the value of the significant fault applicable for a test on one static load shall be calculated in accordance with the test procedures in A.6.1.3. fault greater than 0.25 of the maximum permissible deviation of each fill for in-service inspection as specified in 2.2.2, for a fill equal to the minimum capacity or rated minimum fill respectively of the filling instrument. The following are not considered to be significant faults, even when they exceed the value defined above: • faults arising from simultaneous and mutually independent causes in the instrument; • faults that imply it is impossible to perform a measurement; • faults that are so serious that they will inevitably be noticed by those interested in the measurement; and • transitory faults that are momentary variations in the indications or operation that can not be interpreted, memorized or transmitted as a measurement result 2022-12-19 09:13:39